![]() ![]() Make sure your operating system is Windows XP.Also recommendations from this article are useful inĭual-boot configurations, where other OS must use SATA controller in AHCI mode, and Windows XPĪs a first OS is using SATA controller in IDE mode. Primary motivation for such a switch is to gain additional performance from disk I/O (SATA NCQ),Įspecially for SSD hardware. (aka ATA-compatible mode) to AHCI mode without reinstalling Windows XP. This article is for users who want to switch SATA controller from IDE-compatible mode Verify everything is OK, allow second reboot if necessary During reboot, make configuration changes in BIOS setup Perform upgrade installation of AHCI driver via Windows Device Manager Find or download F6 textmode AHCI driver for your SATA controller ![]() This article explains how to switch from IDE to AHCI after installation of Windows XP, how to change disk controller mode from IDE to AHCI without reinstalling Windows. Unfortunately, if you decide to switch between IDE and AHCI after installing Windows, you will get a BSOD (blue screen of death) during the next boot. AHCI mode works faster and has more features, while IDE compatible mode requires no special drivers to install older operating systems like Windows XP. You can switch between them the in BIOS setup. How To Change Disk Controller Mode From IDE to AHCI Without Reinstalling Windows XPĭisk controller for SATA HDDs can operate in both AHCI and IDE compatible mode. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |